![]() Recomputes Doppler using predicted satellite motion from the broadcast ephemeris. This will produce average velocity values between measurement samples that are relatively noisy. Calculates Doppler from the change in L1 phase measurements between consecutive epochs. This is because data gaps early in the file may cause errors computing the expected data interval. Setting the interval here may be required for successful conversion of RINEX data that contains data gaps in the first minute of the file. If this fails, enable this option to force an interval. The decoder attempts to determine the data interval by reading the header or scanning the observation file. The default value is 0 cycles, as most manufacturers remove the offset at the firmware level, but this is not always the case. Auto will set the entire file static or kinematic according to the detected processing environment. See Pre-processing Checks for more information. If enabled, data is scanned after conversion to correct potential issues. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |